Current Version 4.06

Changes from 4.05
 -Changed flash write sequencing code reduce chances of bricking unit 
 if flash write interrupted prematurely.

Changes from 4.04
 -Fixed a bug that caused 709.1 packets shorter than 10 bytes to be dropped.
  This caused network discovery not to work properly
 -Added in a fail safe so that if a router has trouble reading data from 
  the 709.1 interface chip it will make several retrys and if it still 
  fails the router will reboot.

Changes from 4.03
 -Added back in beacon checking for wifi driver to allow for redundant 
  access points, but upped timeout from 3 to 15 beacons
 -Added 852 out of order packet detection and reordering of out of order
  packets.
 -Changed the spi access algorithm of the RTC to match that of the AVR
  so that there will not be conflicts with the spi clock state.

Changes from 4.02
 -A Few minor interface changes were made
 -The NetOS Wifi driver was enhanced to be more reliable when the wifi
  units are running using infastructure mode.
 -Added support for routing of packets when a network is configured
  in a domain with domain length being 0

Changes from 4.02b2
 -Added MD5 Authentication for the 852 channels as per the 852
  specification. 
 -Changed a few more refrences to the two sides of the router so that they
  display appropriatly in bridgeing mode.

Changes from 4.02b1
 -Added enhancement to Router to enable 852 configuraion to be serialized
  and throttled.  This can be used in situations where there is a very
  low bandwidth link between routers.
 -Fixed the Clear Routing Config button so that it no longer sets the 
  IP configuration back to defaults.

Changes from 4.01
 -Added enhancment to bridging mode that allows the two sides of the
  bridge to operate in independant modes, one manual and one normal
 -Changed refrences to sides of the router from near side far side to 
  Side A Side B.

Changes from 4.00b5
 -Fixed the LonMark ProgramID to report tranceiver types correctly
 -Combined CNS and Adept Versions of firmware into one version
 -Added button to Clear bootup log on diagnostics page
 -Added button to Clear router configuration on RouterSetup page
 -Moved Node ID storage to AVR eeprom instead of ME Flash
 -Fixed an issue where the router would send out 852 channel Registration
  messages when configured in manual mode.

Changes from 4.00b4
 -Added RTC time read out to main webpage and ability to set time
 -Added Visablity of Device Code
 -Enabled functionality of optional features via keys
 -Added Bootup Log in diagnostics page
 -Changed Procedure for Resetting node to defaults
 -Fixed a bug that could cause node to reset to defaults under high traffic load
 -Made the pressing of service pins more reliable when the unit is transmitting on the 709.1 side

Changes From 4.00b3
 -Combined two packet status flags to one flag to prevent possible lockup of transmissions.

Changes from 4.00b2

-This code has all the varius changes we made to the MAC and Interrupts to stabalize the over all
performance and fix the problem we had with 400b1 where we sent out bad packets(two packets pended together)